Complete Installation - KitchenAid KCGC506JSS Installation Instructions Manual

Install Burner Caps
Place burner caps on top of burner. If burner caps are not
properly positioned, surface burners may not light and burner
flames will be uneven and unstable.
Burners
Electronic Ignition System
nitial Lighting and Gas Flame Adjustments
I
Cooktop burners use electronic igniters in place of standing
pilots. When the Cooktop Control Knob is turned to any position,
the system creates a spark to light the burner. This sparking
continues until the flame is lit or the knob is turned to OFF.
NOTE: The first time igniting the burners will take longer. This
allows the gas to reach the burners during the first use.
12

Complete Installation

A
B
A. Incorrect
B. Correct
A
B
Check Operation of Cooktop Burners
Push in and turn each Control Knob to .
NOTE: You will hear a clicking sound while the line clears.
The surface burners and grill flames should light within
4 seconds. The first time a burner is lit, it may take longer
than 4 seconds to light because of air in the gas line.
After verifying the proper burner operation, turn the Control
Knobs to OFF.
If burners do not light properly:
Turn Cooktop Control Knob to OFF.
■
Check that the cooktop is plugged in and the circuit breaker
■
has not tripped or the fuse has not blown.
Check that the gas shut‑off valves are set to the
■
open position.
Check that burner caps are properly positioned on
■
burner bases.
Repeat startup. If a burner does not light at this point, contact
your dealer or authorized service company for assistance.
Flame Height
The cooktop flame should be a steady blue flame.
NOTE: Flame heights are factory set. If they don't appear
correct, please contact your service provider.
Burner
A
B
A. Upper (main) flame
B. Lower (simmer) flame
NOTE: Dual Stacked burner shown.