Table of Contents
Advertisement
Installation
Installation of Decoration Panel (1 Way)
The decoration panel has its installation
direction.
1. Open the air outlet vane, and extract side covers.
2. Remove the air inlet panel from the decoration panel.
3. Hook decoration panel to indoor unit, using hooks attached at the backside of both side of decoration panel.
4. Arrange wires not to get caught between decoration panel and indoor unit.
5. Screw 7 fixing screws. (7, 9, 12 kBtu : 6 screws)
6. Connect the vane motor connector ,display connector and air inlet panel connector.
7. Install the air inlet panel (including the air filter) and side covers.
Air conditioner unit
Plasma filter
(applied only to plasma model)
Decorative panel
Air outlet vane
Decorative panel
Air outlet vane
CAUTION
!
Install certainly the
decoration panel.
Cool air leakage
causes sweating.
⇨ Water drops fall.
22
Indoor Unit
Before installing the decoration panel,
always remove the paper template.
Good example
Fit the insulator (this part) and
be careful for cool air leakage
Mesh
Control box cover
Side cover
Decorative panel
fixing screws
(hexagon M6 screws)
(tightening about 20 mm)
Air inlet panel
Side cover
Decorative panel
fixing screws
(hexagon M6 screws)
(tightening about 20 mm)
Bad example
Air conditioner
unit
Ceiling
board
Decoration panel
Air inlet grille
Air conditioner unit
Air
Cool air leakage
(no good)
Ceiling
board
Decoration
panel
Advertisement
Table of Contents
