Table of Contents
Advertisement
Installation of Decoration Panel
The decoration panel has its installa-
tion direction.
1. Temporarily fix two decoration panel fixing screws (hexagon M5 screw) on the unit body.
(Tighten by amount 10 mm in length.) The fixing screws (hexagon M5 screw) are in-
cluded the indoor unit box.
2. Remove the air inlet grille from the decoration panel. (Remove the hook for the air inlet grille cord.)
3. Hook the decoration panel key hole (
the panel so that the screws reach the key hole edge.
4. Retighten completely two temporarily fixed screws and other two screws. (Total 4 screws)
5. Connect the louver motor connector and display connector.
6. After tightening these screws, install the air inlet grille (including the air filter).
Air conditioner unit
Piping side
Louver motor
Decorative panel
Push
Ratch
pull
CAUTION : Install
certainly the dec-
oration panel.
Cool air leakage
causes sweating.
⇨ Water drops
fall.
) on the screws fixed in step above, and slide
Inlet Grille
Good example
Air conditioner
unit
Decoration panel
Fit the insulator (this part) and
be careful for cool air leakage
Before installing the decoration panel, al-
ways remove the paper template.
Decorative panel
fixing screws
(hexagon M6 screws)
Temporary fitting
at 2 poles
(Tightening about 10 mm)
Control box cover
Plasma filter
Key holes
Decorative panel
fixing screws
(Hexagon M6 screw)
Bad example
Cool air leakage
(no good)
Ceiling
board
Installation Manual 9
Installation
Cover
Air conditioner
unit
Ceiling
board
Decoration panel
Advertisement
Table of Contents
