Table of Contents
Advertisement
tivate the activated settings by re-
peatedly pressing on the relevant
buttons on the display.
ATTENTION!
Pressing on the display with force
may cause damage.
Do not apply heavy pressure on
▶
the display.
Do not press on the display using
▶
pointed or sharp objects.
1
first time
6 Before using for the
first time
Prepare the appliance for use.
first time
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
Press
.
1.
The switch-on process takes a few
seconds.
Set the Drum Clean programme.
2.
Close the door.
3.
Pull out the detergent drawer.
4.
2
Pour approx. 1 litre of water into
5.
the manual dosing compartment.
Add washing powder to the
6.
manual dosing compartment.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
Push in the detergent drawer.
7.
Press
(Start / Pause) to start
8.
the programme.
a The display shows the remaining
programme duration.
a After the programme has ended,
the display shows: End.
Start the first wash cycle or press
9.
to switch off the appliance.
→ "Basic operation", Page 31
first time en
19
Advertisement
Table of Contents
