Filling The Detergent; Using Combined Detergents; Rinse-Aid Usege; Filling The Rinse-Aid And Setting - Sharp QW-S12I492X-FR User Manual

Fullsize dishwasher
Table of Contents

Advertisement

4.8. Filling the detergent

Push the latch to open the dispenser and
pour in the detergent.
Close the lid and press it until it locks in
place. The dispenser should be refilled just
before the start of each programme. If the
dishes are heavily soiled, place additional
detergent in the pre-wash detergent
chamber.

4.9. Using combined detergents

These products should be used according
to the manufacturer's instructions.
Never put combined detergents into the
interior section or the cutlery basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the combination.
We recommend you do not use combined
detergents in short programmes.
Please use powder detergents in such
programmes.
If you encounter problems when using
combined detergents, please contact the
detergent manufacturer.
When you stop using combined detergents,
make sure that water hardness and rinse
aid settings are set to the correct level.
4.10. Rinse-aid usage
Rinse-aid makes dishes sparkle and
helps them to dry without spotting. Rinse-
aid is required for stain-free utensils
and clear glasses. Only use rinse-aid
which is designed to be used in domestic
dishwashers.

4.11. Filling the rinse-aid and setting

To fill the rinse aid compartment, open
the rinse-aid compartment cap. Fill the
compartment with rinse aid until the MAX
level and then close the cap. Be careful not
to overfill the rinse aid compartment and
wipe up any spills.
In order to change the rinse aid level,
follow the below steps before turning on
the machine:
Push the programme button and hold it
down.
Turn on the machine.
Hold down the programme button until
all leds blink twice. Rinse aid setting
follows water hardness setting.
The machine will display the current
setting.
Change the level by pushing the
programme button.
Switch off the machine to save the
setting.
The factory setting is "4".
If the dishes are not drying properly or are
spotted, increase the level. If blue stains
form on your dishes, decrease the level.
Level
Brightener Dose
1
Rinse-aid not
dispensed
2
dispensed
3
2 doses are
dispensed
4
3 doses are
dispensed
5
4 doses are
dispensed
EN - 11
Indicator
P1 LED is on
1 dose is
P2 LED is on
P3 LED is on
P1-P3 LEDs are on
P2-P3 LEDs are on

Advertisement

Table of Contents
loading

Table of Contents