Yaesu MARK-V FT-1000MP Operating Manual page 18

A I
CCESSORY NSTALLATION
D
IGITAL
Construct a patch cable or cables to make the nec-
essary connections between your TNC and the appro-
priate rear panel jack(s) (RTTY for FSK, PACKET for
AFSK). Refer to the pin-out diagram below, and the
wiring instructions included with your TNC. A descrip-
tion of the PACKET jack's individual pins follows:
Pin 1 ( DATA IN ) - Connect this pin to your TNC's
"AFSK Out" or "Mic Audio" output line. The optimum
input level is 30 mV rms, and the input impedance is 3
k . Your TNC's audio output level potentiometer will
allow you to set the level to the optimum value. This
pin may be used either for 300 baud SSB-mode digital
operation or for 1200-baud FM packet. The bandwidth
and frequency response are not, however, suitable for
9600 baud operation.
Pin 2 ( Ground ) - Connect this to the shield(s) of
the cable(s) used for connections between the TNC
and the MARK-V FT-1000MP.
Pin 3 ( PTT ) - Connect this pin to the PTT line from
the TNC. This pin, when grounded by the TNC, places
the MARK-V FT-1000MP into the Transmit condition.
Pin 4 ( DATA Out ) - Connect this pin to your TNC's
"RX Audio" input line. This is a constant-level (100 mV
rms @ 600 ) audio output line which is not affected
by the position of the front-panel AF GAIN control.
Pin 5 ( BUSY ) - This is a "Squelch Status" pin not
generally required for digital mode operation. This pin
is held at +5V when the squelch is open, and is
grounded when the receiver is muted by the squelch
("no-signal" condition).
MARK-V FT-1000MP
page 16
( TNC, W
M
ODEM
. ) I
F ,
EATHER AX ETC
For FSK operation using the RTTY jack, the fol-
lowing are the pin connections required:
Pin 1 ( SHIFT ) - Connect this pin to your TNC or
terminal unit's "FSK Key" port. Closing and opening of
this line to ground causes mark/space keying.
Pin 2 ( RX AF OUT ) - Same as "DATA OUT" on
PACKET jack.
Pin 3 ( PTT ) - Same as "PTT" on PACKET jack.
Pin 4 ( GND ) - Same as "GND" on PACKET jack.
For operation on PSK31, connect your computer's
sound card to the PACKET jack (for "PKT" mode op-
eration) or the MIC and EXT SP jacks (for "SSB" mode
operat i on) . Al so, use
the "User" mode (see page 110) for PSK31 operation.
For most operation, you will want to use the PS31-
U (for PKT mode) or PS31-SU (for USB mode) op-
tions under "East Set;" while BPSK operation is not
sideband-sensitive, QPSK operation, by convention,
utilizes USB-side injection.
The "User" mode is accessed, during operation, by
pressing and holding in for ½ second the [ PKT ] mode
switch.
MARK-V FT-1000MP Operating Manual
NTERFACING
menu selection 8-6 to configure
TNC