Vivotek FD8165H User Manual page 53

■ Exposure Time: The configurable max. exposure time is tunable according to lighting conditions
with values ranging from 1/10000 to 1/5 of a second.
■ Gain Control: Tune the slider bar to set the Gain Control to the best image quality. Higher gain
control value will generate a certain amount of noises.
You can click Restore to recall the original settings without incorporating the changes. When
completed with the settings on this page, click Save to enable the settings.
■ WDR Pro : When enabled, you can select the strength of the WDR function. The Low, Medium,
High options correspond to the level of contrast between the overly-lit area and the shaded areas.
For example, the High option applies to a high contrast scenario. Note that when the exposure
time is set to longer than 1/60 second, the WDR function will be disabled.
The Sensitivity option applies to the response speed to the change in bright-to-dark lighting
contrast.
If you want to configure another sensor setting for day/night/schedule mode, please click Profile to
open the Profile of exposure settings page as shown below.
Activated period: Select the mode this profile to apply to the Schedule mode. Please manually enter
a range of time if you choose Schedule mode. Then check Save to take effect.
Please follow the steps below to setup a profile:
1. Select the Enable and apply this profile to
checkbox.
2. Select the applied mode: Day mode, Night mode,
or Schedule mode. Please manually enter a range
of time if you choose the Schedule mode.
3. Configure Exposure control settings in the folowing
columns. In this way, you can tell the camera to
adapt to special lighting conditions, say, during the
night time, by setting a profile for the night hours.
Please refer to previous dicussions for detailed
information.
4. Click Save to enable the setting and click Close to
exit the page.
VIVOTEK
User's Manual - 53