Connect Power - Uniden GNS8350 Owner's Manual

3 MOUNTING
Glass Mount Bracket
1. Make sure the glass area you wish to attach the Glass Mount Bracket to is
clean.
2. Double check that the final location does not impede the safe operation
of the vehicle.
3. Hold the Glass Mount Bracket up to the intended position and bend
the bracket arm if needed. With the release lever loose firmly press
the suction cup against the windscreen, push the release lever to secure
suction. (fig 1).
Attach main unit
Secure unit to bracket. (fig 2).
1. Flip up the antenna located at the rear of the main unit.
2. Sit the main unit on the two locating pegs at the bottom of the
mounting bracket.
3. Squeeze together the two grey release buttons on the mounting
bracket and rock the main unit back onto the bracket.
4. Release the two grey buttons and check the unit is secure.

Connect Power

1. Insert DC plug of Cigarette Lighter Lead into the DC Power
socket of your GNS8350 and connect the other end to the +12V -
24V cigarette lighter socket.
Ensure the cord does not interfere with safe
vehicle operation
iv
Secure
Press
Fig 1: Line up glass mount to
windscreen
Antenna
Secure
Release
buttons
Locating Pegs
Fig 2: Secure unit to bracket