Table of Contents
Advertisement
Installation
Installation underneath the
wall unit
When selecting the installation position,
ensure that the recirculation grille at the
front of the appliance are not covered
by the wall unit.
Opening for exhaust duct and power
cord
Attach the pre-cut drilling template to
the bottom of the wall unit.
When using the vented mode, cut an
opening in the bottom of the cabinet
that is at least 6 ¹¹/₁₆" (170 mm)
If the power cord must be fed
through the cabinet, a hole is required
for it the unit as well.
30
Attachment from the top
Use only the attachment points
shown on the drilling template and
the screws supplied.
Incorrect attachment can lead to
damage to the hood and could
compromise electrical safety (e.g.
electric shock).
Use the drilling template to drill
four ³/₁₆" (5 mm) ( fixing holes
through the bottom of the cabinet.
Remove the drilling template.
Advertisement
Table of Contents
