Hoshizaki DCM-271BAH Instruction Manual page 23

6) Move the power switch to the "OFF" position, then unplug the appliance from the
electrical outlet.
7) Remove the front panel, top panel, and bin top.
8) Pour clean, warm water into the ice storage bin and melt any remaining ice. Remove the
agitator. Pour clean, warm water over the extruding head until the evaporator assembly
and the reservoir are full and the water starts to overflow into the drain pan. Plug the
appliance into the electrical outlet, then move the power switch to the "ON" position.
Allow the water system to drain completely.
9) Move the power switch to the "OFF" position, then unplug the appliance from the
electrical outlet.
10) Move the control switch to the "ICE" position. Replace the air filter, louver, agitator, bin
top, and panels in their correct positions.
11) Open the water supply line shut-off valve to supply water to the reservoir. Plug the
appliance into the electrical outlet. Move the power switch to the "ON" position to start
the automatic icemaking process. Allow the appliance to run for 30 minutes.
12) Move the power switch to the "OFF" position, then remove the louver and air filter. Move
the control switch to the "DRAIN" position, then move the power switch to the "ON"
position. Allow the water system to drain completely.
13) Dispense all of the ice from the ice storage bin.
14) Move the power switch to the "OFF" position, then unplug the appliance from the
electrical outlet.
15) Remove the front panel, top panel, and bin top. Remove the agitator and drip ring.
16) Wipe down the inside of the ice storage bin, inside of the bin top, the agitator, and drip
ring with a clean cloth.
17) Move the control switch to the "ICE" position. Replace the air filter, louver, drip ring,
agitator, bin top, and panels in their correct positions. On the push-button model,
reconnect the connector. WARNING! CHOKING HAZARD: Ensure all components,
fasteners, and thumbscrews are securely in place. Make sure that none have
fallen into the ice storage bin.
18) Plug the appliance into the electrical outlet, then move the power switch to the "ON"
position to start the automatic icemaking process.
23