Table of Contents
Advertisement
Time setup / Lithium battery
1
Connect the power plug. Press
beep sound. The time shows in the LCD starts to blink.
2
Press
or
button to set the time (1 minute increment).
Keeping the button pressed will make setting faster.
• 24:00 is replaced by 0:00.
• Error may occur in the Timer function if the current time has not been set properly.
• The time cannot be setup during operating state.
3
The time will be automatically set after leaving about 5 seconds (LCD stops blinking).
Power source for the clock
■
When unplugged
The internal
lithium battery is
fully utilized.
■
When plugged
The power supply
source is fully
utilized.
Time setup
or
button for more than one second, then release the button after a
Lithium battery
Battery Replacement
If lithium battery is fully utilized, please
contact authorized service center for replacement.
■
The life time of battery is around 5 years (At 20°C
room temperature and plugged in 12 hours each
day).
■
When the battery is consumed, the following
phenomenon will happen:
• The clock becomes vague or disappear.
• Memory of preset time is lost.
• The clock can be used again when power plug is
connected.
(The clock resetting is required).
Note: Do not put the lithium battery into the fire, do
not recharge, disassemble or heat the battery, etc.
5
Advertisement
Table of Contents
