Table of Contents
Advertisement
Rinse the heat exchanger and the cap on all sides with
7.
a jet of water to completely remove all of the lint and
fluff.
Remove all lint and fluff from the seals on the dryer
8.
and heat exchanger.
Allow the cap and the heat exchanger to dry fully.
9.
First insert the heat exchanger, then the cap.
10.
Turn back both locking levers.
11.
Close the maintanance flap until it locks into position.
12.
Look in the Troubleshooting table to reset the
13.
maintenance indication.
~ Troubleshooting; Page 31
Cleaning the moisture sensors
The dryer is equipped with a stainless-steel moisture
sensor. The moisture sensor measures how damp the
laundry is.
After long periods of usage the moisture sensor may
become covered by a fine layer of limescale or residues
of detergents and textile care products. Such residues
must be removed regularly as the sensor function and in
consequence the drying result may be impaired.
30
To clean the moisture sensors:
Open the door.
1.
The deposit on the sensors can easily be removed by
2.
wiping the sensors (the two bars next to the lint filter)
with a cloth and a little white vinegar.
NOTICE: Use white vinegar only!
Clean the moisture sensors once a month.
Cleaning the lint filter area
Over time, lint from the drying process collects in the lint
filter area.
This lint can be easily removed using a vacuum cleaner.
Maintenance of drain hose
If DR indicator lights up check the drain hose for kinks,
restrictions or blockage.
NOTICE: If DR indicator still lights up after the
maintenance, you should contact customer service or
your local dealer.
Advertisement
Table of Contents
