Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Durapac 15 Series
Summary of Contents for Durapac 15 Series
- Page 1 Instruction Manual 15 Series Auto 2 Speed Electric Power Unit Model – PES1514 Maximum Operating Pressure – 700 bar ABSOLUTE EQUIPMENT PTY LTD – 2/186 Granite Street, GEEBUNG QLD 40 34 – Australia sales@absoluteequipment.com.au – Phone: +61 7 3865 4006 –...
- Page 2 The user must ultimately make the decision regarding suitability of the product for any given task and assume the responsibility of safety for all in the work area. Contact a Durapac representative if you are unsure of your power unit’s suitability for a particular application.
- Page 3 Hydraulic equipment must only be serviced by a qualified hydraulic technician. For repair service, contact the Durapac authorised service centre in your area. To protect your warranty, use only high quality hydraulic oil CAUTION: ...
- Page 4 4.1 Familiarise yourself with the specifications and illustrations in this owner’s manual. Know your power unit, its limitations and how it operates before attempting to use. Refer to the specification chart below or if in doubt, contact a Durapac representative. Maximum...
- Page 5 Durapac authorised service centre Damage to hydraulic hoses may not be detected during visual inspections. For this reason, Durapac recommends that hydraulic hoses be replaced on a regular basis Tighten connections as needed. Use non-hardening pipe thread compound when servicing connections PES1514 Electric Power Unit - V1.0...
- Page 6 Wipe clean thoroughly and store in a clean, dry environment. Avoid temperature extremes. 6.4.3 For transportation or long storage, replace the air vent plug with shipping plug. 6.4.4 Shield power unit with a protective cover. PES1514 Electric Power Unit - V1.0 www.durapac.com Page 6 of 8...
- Page 7 Externally adjustable relief valve Reset the relief valve to is not correctly set appropriate level Damaged o-ring Send to a Durapac authorised service centre for repair Defective control valve Send to a Durapac authorised service centre for repair ...
- Page 8 Leaking cylinder seals Replace worn seals. Look for excessive contamination or wear. Replace contaminated fluid Power unit or valve not operating Contact a Durapac authorised correctly service centre for repair Overload condition Remedy overload condition Application does not Closed release valve Secure load by other means.
Need help?
Do you have a question about the 15 Series and is the answer not in the manual?
Questions and answers