E.s.p.(External Static Pressure) Setting - LG LBUH366GSS0 Installation Manual

E.S.P.(External Static Pressure) Setting

Open the rear cover of the wired remote-controller to set the mode.
Select one of three selectable modes as follows.
I Without Zone System
1. Position V-H, F-H:
• This position sets the maximum E.S.P as a default set.
2. Position V-L:
• This position sets the minimum E.S.P as a default set.
I With Zone System
1. Position V-H:
• Maximum E.S.P setting & Fan speed is varied according to the state of dampers by micom.
2. Position F-H:
• Maximum E.S.P setting & Fan speed doesn't vary according to the opening & Closing of
dampers.
3. Position V-L:
• Minimum E.S.P setting & Fan speed is varied according to the state of dampers by micom.
*Maximum: 30k(H/P)-10mmAq, 30k(C/O)/36k/42k-8mmAq, 48k/60k-15mmAq
Minimum: All-0mmAq
Move the slide switch to set position.
Slide switch for zone state/Default E.S.P
Close the rear cover and check if it works normally.
CAUTION:
• Select the position after checking duct work and E.S.P of the unit.
• Maunfactured in the position F-H.
V-L
F-H
V-H
E.S.P.(External Static Pressure) Setting
TH R13H R12H
OP5R16H OP4
CO1H
R15H
OP3 OP2 OP1
R14H
R19H
SW TH
R11H
REMO
MAIN
OP7
2TH
R18H
R17H
OP6
LO
STAND
R03S
HI
R01S
SW HIGH
Installation Manual 29