Cancelling The Programme; Salt Indicator ( ); Rinse Aid Indicator ( ); End Of Programme - Beko DIT16221 Instruction Manual

C
Pay attention not to open the door
of the machine when it is running.
There may be a rush of vapour
when you open the door of your
machine; be careful.
C
The machine will remain silent in
pause mode for some time in order
to remove the water in the machine
and on the dishes completely and
to have the water softener cleaned,
and then it will resume running in
drying mode.

Cancelling the programme

Press and hold the Programme
Selection / Programme Cancel keys for
3 seconds. Release the key as the Start
indicator starts flashing.
Once you close the door of your
machine, draining is completed in 2
minutes
and the machine gives an audible
warning when it is completed.
C
There might be residues of
detergent or rinse aid in the
machine and/or on the pieces being
washed depending on the step the
programme you have cancelled was
in.

Salt indicator ( )

Please check the salt indicator on
the display to see whether there is
adequate amount of softening salt
in the dishwasher or not. You need
to refill the salt reservoir with salt
whenever salt indicator appears on the
display of your machine.
C
Adjusting the water hardness level
is explained in Water Softening
System section.

Rinse Aid indicator ( )

Please check the rinse aid indicator
on the display to see whether there
is adequate amount of rinse aid in the
dishwasher or not. You need to refill
the rinse aid reservoir with rinse aid
whenever rinse aid indicator appears
on the display of your machine.

End of programme

C
When the programme you have
selected comes to an end, an
audible warning signal will warn
you to turn off your machine. This
audible signal will warn you with
certain intervals before it turns
off.
End of Programme indicator will light
up when the washing programme is
over.
1. Open the door of the machine.
2. Press On/Off key to turn off your
machine.
3. Close the tap.
4. Unplug the machine from the
socket.
C
For energy saving, the machine is
automatically turned off following
the completion of the programme
or if the programme is not started.
C
Leave your dishes in the machine
for about 15 minutes to allow
them cool down after they are
washed. Your dishes will dry in a
shorter time if you leave the door
of your machine ajar during this
period. This process will increase
the drying effectiveness of your
machine.

Water cut-off warning

If mains water is cut or water inlet
tap is turned off the machine cannot
take water in and P2 icon will flash
on the programme indicator. As
long as the problem continues,
washing programme is paused and
the water inlet is checked regularly
by the machine; when the water is
35 EN