Table of Contents
Advertisement
Quick Links
1 Channel Video Receive Unit with Bi-directional Data
Channel over One Single Mode Fibre
The AMG4714R-SF is a rackmount one channel video receive unit designed to receive 1 video signal
and transmit and receive 1 data signal over one singlemode fibre.
The AMG4714R-SF is designed to plug into an AMG2005 subrack, which in turn fits into a 19" rack
system.
The AMG4714R-SF is designed to operate with AMG4713-SF or rackmount equivalent AMG4713R-
SF one channel video transmit unit in a point to point configuration.
AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
AMG4714R-SF
Instruction Manual
Page 1 of 8
AMG4714R-SF Instruction Sheet
D32030.doc
Advertisement
Table of Contents
Related Manuals for AMG AMG4714R-SF
Summary of Contents for AMG AMG4714R-SF
- Page 1 The AMG4714R-SF is a rackmount one channel video receive unit designed to receive 1 video signal and transmit and receive 1 data signal over one singlemode fibre. The AMG4714R-SF is designed to plug into an AMG2005 subrack, which in turn fits into a 19" rack system.
- Page 2 Removal / replacement from / to the Case ..................7 Safety Maintenance and Repair AMG Systems Ltd. reserves the right to make changes to this Page 2 of 8 AMG4714R-SF Instruction Sheet document without notice. The information herein is believed to D32030.doc...
- Page 3 It also transmits 1 data signal to the AMG4713R-SF. Optical Connection The AMG4714R-SF is connected as illustrated below when used with an AMG4713R-SF 1-channel transmit unit acting as a point to point system. AMG Systems Ltd. reserves the right to make changes to this...
- Page 4 RS232 – switch position – low (furthest from BNC connections) DATA CHANNEL B Data Channel B ........Not Present AMG Systems Ltd. reserves the right to make changes to this Page 4 of 8 AMG4714R-SF Instruction Sheet document without notice. The information herein is believed to D32030.doc...
- Page 5 RS485 bus high (+5 volts) and the other arm low (0 volts) using high value resistors within the third party equipment. In order to ensure that the AMG equipment detects a tri-state condition, then these resistors should have a value above 5kΩ. If the third party bias resistors are less the 750Ω...
- Page 6 OUT+ logic one (-V) present on OUT+ This represents the data signals being received on the optical fibre AMG Systems Ltd. reserves the right to make changes to this Page 6 of 8 AMG4714R-SF Instruction Sheet document without notice.
- Page 7 There are no user serviceable parts within AMG products. See unit data sheet for full specification. In case of problem or failure, please call your local support centre or contact: AMG Systems Ltd. at 3 The Omega Centre, Stratton Business Park, Biggleswade, Beds., SG18 8QB, UK.
- Page 8 This page is intentionally blank. AMG Systems Ltd. reserves the right to make changes to this Page 8 of 8 AMG4714R-SF Instruction Sheet document without notice. The information herein is believed to D32030.doc be accurate. No responsibility is assumed by AMG for its use.
Need help?
Do you have a question about the AMG4714R-SF and is the answer not in the manual?
Questions and answers