Operating Procedures - TEC EM1-31076 Owner's Manual

13. OPERATING PROCEDURES

13. OPERATING PROCEDURES
Do not exceed the platter weight of maximum capacity. Or hang any item from the scale which
exceed the platter weight.
■
NOTES BEFORE STARTING OPERATION
(1) Turn the power ON.
(2) A sixteen-second scanning will be performed after pressing the
(3) Should a power failure occur during operation, remove the commodity from the platter
and insert the power plug into an AC outlet again when power is restored.
(4) If the scale is used with an unrated power source, inaccurate scaling or other errors may
occur.
(5) If the zero point has shifted during scaling, and no tare is displayed, adjust the zero point
by depressing the
(6) Check the date of the scale before operation every day.
(7) Make a test print before operation every day.
Press the
■
How to access REG., M.DOWN, or REWRAP menu
The following display is the REG. menu display. When this display is shown after pressing
the
POWER
<REG.> MANU.
ENTER THE PLU #
To access a menu from other menus, press the
enter the menu No. When the M.DOWN and REWRAP menus are protected, enter the
menu No. and then the password.
<Menu>
0. PROG.
1. REG.
2. MARK DOWN
3. REWRAP
4. SECURITY
NOTE: If a label nothing is printed on is issued after a printed label in batch mode, refer to
Section 10.11 and press the
key.
ZERO
key, and the test label is issued.
TEST
key, you can start the REG. operation right away.
WEIGH
lb UNIT/$
0.000
5. REPORT
6. RESET
7.
8.
9.
WARNING!
TOTAL $
P 000000
key to show the Main menu and
ESC.
key.
SET NEXT
13- 1
■ NOTES BEFORE STARTING OPERATION
key.
POWER