Operating Procedures - TEC SL-9000 Owner's Manual

Electronic computing scale
Hide thumbs Also See for SL-9000:
Table of Contents

Advertisement

14. OPERATING PROCEDURES

14. OPERATING PROCEDURES
NOTES BEFORE STARTING OPERATION
(1) Insert the power plug into the AC outlet and turn the power ON.
(2) A sixteen-second scanning will be performed after pressing the
(3) Do not move the unit while it is in operation. Should it become necessary to move it at
any time, turn the power switch to the OFF position and be sure to readjust the level
indicator after relocating the scale.
(4) Should a power failure occur during operation, remove the commodity from the platter
and insert the power plug into an AC outlet again when power is restored.
(5) If the scale is used with an unrated power source, inaccurate scaling or other errors may
occur.
(6) If the zero point has shifted during scaling, and no tare is displayed, adjust the zero point
by depressing the
(7) Check the date of the scale before operation every day.
(8) Make a test print before operation every day.
Press the
How to access REG., M.DOWN, or REWRAP menu
The following display is the REG. menu display. When this display is shown after pressing
the
POWER
<REG.> MANU.
ENTER THE PLU #
To access a menu from other menus, press the
enter the menu No. When the M.DOWN and REWRAP menus are protected, enter the
menu No. and then the password.
<Menu> MAIN
0. PROG.
1. REG.
2. MARK DOWN
3. REWRAP
4. SECURITY
NOTE: If a label nothing is printed or is issued after a printed label in batch mode, refer to
Section 11.11 and press the
key.
ZERO
key, and the test label is issued.
TEST
key, you can start the REG. operation right away.
WEIGH
lb
UNIT/$
0.000
P
5. READ
6. RESET
7.
8.
9.
TOTAL $
000000
ESC.
key to show the Main menu and
key.
SET NEXT
14- 1
■ NOTES BEFORE STARTING OPERATION
key.
POWER

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents