Table of Contents
Advertisement
2
Product Overview
2.8 – Maintenance Check
Check the unit for dents, punctures, case distortion or misalignment, and cracked or loose connectors. Check
cables for cuts, chafing or evidence of crushing. Check connectors for cracks, cuts, distortion, excessive
wear, broken or loose fasteners, and cables or strain relieves. If no external damage is evident, proceed to
next step. Otherwise contact Tesla™ for further instructions.
2.9 – Pre-Installation Procedures
Removing Original Battery
Follow the aircraft's operator manual procedures to remove and dispose of the original aircraft battery
properly and safely. Once the original battery has been removed from the battery compartment, proceed to
the next step.
Check Unit Charge State
Before installing the unit into the aircraft, make sure the unit is fully charged. Remove the ac line cord from
the ac input connector and wait two minutes. Then, push the "Press for Capacity" button to verify that the
power cells are fully charged. Under a full charge the Capacity Meter will show a single green LED.
!
NOTE
8
If the unit is not fully charged after 281 minutes, the power cells may need
to be replaced. Return the unit to Tesla™ Industries for evaluation and
maintenance.
TI5679 MPU-24
15
Advertisement
Table of Contents
