Installation - Samsung SUD-2080N User Manual

Installation

When installing on a adapter plate
1) Place the bracket provided on the installation
An arrow for installing directions
Adapter plate
2) When placing the camera body on the plate,
3) When placing the camera body on the plate,
M4 tapping
screw (provided)
4) After installation and adjustment of the camera
CAMERA
Locking
direction
Unlocking
direction
Dome cover
Notes
• Please locate an arrow on bracket for installing direction that you wish to observe
Area and then fix it with the M4 tapping screws.
12
COLOR DOME CAMERA
surface and fix it with the M4 tapping screws
(provided).
insert the plate pin into the mounting hole on
the body as shown in figure 2 and fix it by
turning clockwise.
make sure the camera cables pass through their
respective designated holes.(When placing the
cable through its side, thread it through the
hole at the bottom.)
are complete, secure the dome cover by turning
it clockwise.
Plate pin
Locking direction
Unlocking direction
[Figure 2]
User Guide
Adjust the panning, tilting and rotate mechanism while checking the position on the monitor
145˚
170˚
Pan Base
-170˚
1) You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
• Pan Bracket moves by 170° in each direction or 340° on the whole.
• Tilt Body covers 73° in each direction or 146° in total.
• T he angle range of the Rotate Body is the same as that of the Pan Bracket. But one
direction range is 195° and another is 145°
2) Methods of adjustment
•
The case of wall installation
After mounting the camera on a wall, adjusting the panning angle so that the camera can
... 1
face the direction to monitor when tilted.
Adjust the tilting angle by rotating the tilt base.
... 2
Loosen the rotate base hold screw and adjust rotate base for the best view.
... 3
Tighten the rotate base hold screw.
... 4
•
The case of ceiling installation
... 1 After mounting the camera on a ceiling, adjusting the panning angle to the correct viewing
position by rotating the pan base.
Adjust the tilting angle by rotating the tilt base.
... 2
... Loosen the rotate base hold screw and adjust rotate base for the best view.
3
Tighten the rotate base hold screw.
... 4
COLOR DOME CAMERA
73˚
195˚
Tilt Base
Rotate Base
13
User Guide