Panasonic Micro SD AW-HN40HWPC Operating Instructions Manual page 89

Web screen configurations
„ Host authentication screen [Host auth.]
„
Click the [Host auth.] tab of User mng. screen [User mng.].
Configure the host authorization settings that restrict the
personal computers (IP addresses) that can access the unit.
Host auth.
Host authorization is set to "On" or "Off" here.
Factory settings: Off
IP address
The IP address of the personal computer from which
access to the camera is allowed is input here. The host
name cannot be input as the IP address.
Notes
● When the "IP address/subnet mask length" is input,
the personal computers which are allowed to access
the camera can be restricted on a subnet by subnet
basis.
If, for instance, "192.168.0.1/24" has been input and
the [2. Camera control] setting has been selected as
the [Access level] setting, the personal computers
from "192.168.0.1" to "192.168.0.254" will be able
to access the camera at the [2. Camera control]
access level.
● When an already registered IP address is input and
the [Set] button is clicked, the host information will
be overwritten.
Access level
Select one of the following settings as the host access
level.
Setting value:
1. Administrator This access level allows the user to
perform all the unit's operations.
2. Camera control This access level allows you to display
images and control the unit. The unit
cannot be set.
Factory settings: 2. Camera control
Host check
You can view registered host IP addresses by clicking
for [Host check].
A host is indicated in the form of "Registered IP address
[Access level]". (Example: 192.168.0.21 [1])
You can delete selected hosts (IP addresses) by clicking
the [Delete] button at the right.
(continued)
„ Priority stream screen [Priority stream]
„
Click the [Priority stream] tab of User mng. screen [User
mng.].
Selected on this screen are the settings for the priority
stream which enables the images to be sent with no
reduction in image quality or image refresh speed even
when a multiple number of users are accessing the unit at
the same time.
z Priority stream
„
Activation
Whether to use priority stream transmission is set here
using "On" or "Off".
Factory settings: Off
Note
● When [Activation] is set to [On], the number of users
that can access the unit may be restricted.
Destination IP address (1)
The IP address of the first send destination is input here.
Destination IP address (2)
The IP address of the second send destination is input
here.
Stream Type
Select the stream type.
Setting value:
JPEG(1)
JPEG(2)
JPEG(3)
H.264(1)
H.264(2)
H.264(3)
H.264(4)
Factory settings: JPEG(1)
JPEG(1) images are sent.
JPEG(2) images are sent.
JPEG(3) images are sent.
H.264(1) images are sent.
H.264(2) images are sent.
H.264(3) images are sent.
H.264(4) images are sent.
89