Technical Data; Hints For Test Institutes - M-system MVW-651 Operating Instructions Manual

60
Water drops have
dried onto glasses
and dishes
If after all these checks, the problem persists,
contact your local Service Force Centre.

Technical data

Dimensions
Electrical connection - Voltage -
Overall power - Fuse
Water supply pressure
Capacity

Hints for test institutes

Testing in accordance with EN 60704 must
be carried out with appliance fully loaded and
using the test programme (refer to 'Con-
sumption values').
Test in accordance with EN 50242 must be
carried out when the salt container and rinse
Amount of detergent required:
Rinse aid setting
Arrangement upper basket
The wash results are not satisfactory
• Increase rinse aid dosage.
• The detergent may be the cause. Contact the detergent manufacturer con-
sumer care line.
Width
Height
Depth
Information on the electrical connection is given on the rating plate
on the inner edge of the dishwasher door.
Minimum
Maximum
Full load: 12 standard place settings
aid dispenser have been filled with salt and
rinse aid respectively and using the test pro-
gramme (refer to 'Consumption values').
5 g + 25 g (Type B)
position 4 (Type III)
Cup racks: position A
59,6 cm
81,8 - 87,8 cm
55,5 cm
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
12 place settings