Table of Contents
Advertisement
+00EH97062301.book Page 6 Thursday, March 17, 2011 10:51 AM
Lite-Vision plus Remote Controller
Install the remote controller
NOTE
• Wiring for the remote controller should not be bundled or installed in the same conduit with a power cable.; otherwise,
malfunction may result.
• Install the remote controller away from sources of electrical interference and electromagnetic fields.
1
Insert a flat-blade screwdriver into the groove on the back side of the remote controller to remove
the rear case.
2
Use the wood screws (2 pieces) supplied with the remote controller to attach the rear case of the
remote controller to the wall.
Do not use an electrical screwdriver. Do not over-tighten the screw (Tightening torque is up to 2
kg / f•cm.); otherwise, the rear case may be damaged.
3
Connect the electrical wire from the indoor unit to the terminal block of remote controller.
(Refer to "Wire the remote controller".)
Check the terminal number of electrical wire from the indoor unit to avoid miswiring.
(If AC 200-240 V is applied, the remote controller and indoor unit will break down.)
Wood screw x 2
Remote
controller
<Back side of the remote controller>
Rear case
– 6 –
Installation Manual
EN
Advertisement
Table of Contents
