Attaching The Frame Unit - Yamaha SILENT Bass SVB-100 Owner's Manual

■ Attaching the Frame Unit

The SILENT Bass™ is shipped from the factory with the Frame Unit removed from the
main body.
Please properly attach the Frame Unit using the following procedure.
1
Open the frame unit's armrest until it comes in contact
with the stopper.
2
Fully loosen the [Fixing Knob 2] located on the bottom
end of the main body.
3
Align the cut end of the Frame Unit with the post
above the [Fixing Knob 2] and fully insert. Then, align
the notch at the top of the Frame Unit so it rests on the
top of the bass' main body and slowly insert.
4
Turn the [Fixing Knob 1] located on the upper portion
of the frame unit clockwise until it is tight, to attach
the frame unit to the body.
5
Turn the [Fixing Knob 2] on the bottom end of the
main body clockwise (looking from the bottom) until
it is tight, to attach the frame unit to the body.
6
Align the [Fixing Knob 3], located on the center of the
frame unit, with the Fixing Knob Plate located on the
center of the main body, then turn clockwise to tighten.
W h e n y o u m o v e t h e f r a m e u n i t 's
center section, be careful not to
pinch your fingers, hand, etc.
This completes attachment of the frame unit.
To remove the frame, simply reverse the order of the previous procedure.
• Make sure that Fixing Knobs 1-3 are tightened firmly. If they are left loose, it may result in rattle or
noise during performance.
• When transporting the instrument, always hold it by its neck or main body. Holding by the frame unit
only may result in damage to the frame unit.
3
1
Fixing Knob 3
6
Tighten
3
Fixing Nut 2
Fixing Knob 1
4
Tighten
2
Loosen
5
Tighten
9