Phonic SMARTMAN 708A User Manual page 17

TROUBLESHOOTING
The power won't turn on
4 Is the power supply connected to the unit, and the AC-
end to an appropriate source?
4 Is the AC power outlet turned on?
4 Is the power switch turned on?
4 Check your Smartman's fuse. This is located within the
AC connector, underneath the AC power Connector.
There is no output signal
4 Are the inputs turned on within the software?
4 Are the outputs turned on within the software?
4 Check input levels on both the Smartman's rear panel
and within the software.
4 Check output levels within the software.
Sound is too soft
4 Are gain controls on the rear of the Smartman system
set to an adequate level?
4 Are input and output levels set adequately within the
software?
4 Are your input sources (analog mixers, keyboards,
etc) turned up to an adequate level?
4 Check the Dynamic processor settings on the input
and output mixes are not excessive.
4 If the issue is only related to external expansion
speakers, ensure you have not inadvertently activated
the low pass filter.
Sound is distorted
4 Check that gain settings, input and output settings are
not excessive.
4 Check the DFX menu to see if any effects are applied
to the AUX signal. If so, audition the system without
the DFX on to see if it improves the issue.
4 Could the EQ/DYN gain be set to an extremely high
setting?
SMARTMAN 708A 13