Furniture of America FOA7887CK Assembly Instructions Manual

Download this manual

For more information contact our team: service.ec@foagroup.com

ASSEMBLY RATING

The Assembly Rating is a 5-point system that

shows the degree of effort needed in

assembling a specific product (with 1 being

easy and 5 being difficult). For some

products, two persons are recommended.

EASY

Assembly Instructions

DIFFICULT

FOA7887CK

Tools Required For Assembly:

Allen Wrench

Wrench

Phillips Screwdriver

2 PERSONS RECOMMENDED

Page 1 of 6

(Included)

(Not Included)

Rev: 2019-06-22

Need help?

Do you have a question about the FOA7887CK and is the answer not in the manual?

Page 1 Assembly Instructions For more information contact our team: service.ec@foagroup.com FOA7887CK ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that Allen Wrench shows the degree of effort needed in (Included) assembling a specific product (with 1 being Wrench easy and 5 being difficult).
Page 2 LOOSEN OVER TIME AND MAY CAUSE THE FURNITURE TO BE WOBBLY AND UNABLE TO SUPPORT ITS INTENDED WEIGHT CAPACITY. THIS MAY LEAD TO COLLAPSE AND MAY CAUSE SERIOUS INJURY. FAILURE TO FOLLOW THE GUIDELINES ABOVE MAY RESULT IN INJURY AND/OR PROPERTY DAMAGE. FURNITURE OF AMERICA.ALL RIGHTS RESERVED. Page 2 of 6...
Page 3 Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed. #1 x 1pc #A x 10pcs Headboard Panel Bolt Ø5/16" x 2" #2 x 2pcs #B x 10pcs HB Leg (L&R) Lock Washer Ø5/16"...
Page 4 Exploded View Align HB legs (#2R/L) to headboard (#1) and HB support (#5), then secure by using bolts (#A) with washers (#B,C). # A x 10pcs #B x 10pcs # 2L # C x 10pcs # 2R Page 4 of 6...
Page 5 Attach threaded pins (#F) to the holes of the headboard (#1) and footboard (#3), then align side rails (#4) to the threaded pins (#F) of the headboard and footboard (#1,3). Secure by using half moon washer (#G) with hex nuts (#H). #F x 8pcs # G x 8pcs #H x 8pcs...
Page 6 Align slats (#6) to the side rails, then secure by using screws (#E). #E x 8pcs ASSEMBLY IS COMPLETED Page 6 of 6...