Switch On The Phone; Charge The Battery - Philips CTM600RED/00 Manual

Philips mobile phone ctm600red m600
Table of Contents

Advertisement

Switch on the phone

To switch on the phone, long press ) key. Enter the
PIN code if required. The PIN code is a 4- to 8-digit
secret code of your SIM card. It is preconfigured and
communicated to you by your network operator or
retailer. For more information on PIN codes, see
"Call Settings" on page 52.
If you enter an incorrect PIN code three times in
succession, your SIM card will be locked. To unlock it,
you must obtain the PUK code from your network
operator.

Charge the battery

Your phone is powered by a rechargeable battery. A
new battery is partially charged and a sound alert will
warn you when the battery reaches low. Once you have
installed the battery, you can start charging the phone.
Plug in the charger connector as shown below. Then
plug the other end into a mains AC power socket.
8
The battery symbol indicates the state of charge.
During charging, the charge indicators will scroll. It
takes around 3 hours to fully charge the battery.
When all the scroll bars are steady, the battery is fully
charged. You can then disconnect the charger.
Keeping the charger plugged to the mobile phone
when the battery is fully charged will not damage the
battery.
The only way to turn off the charger is to unplug it, so use
an easily accessible AC power socket.
Getting Started

Advertisement

Table of Contents
loading

Table of Contents