Table of Contents
Advertisement
4
Remove the two screws from the main
unit slot cover.
5
Insert the function board to the main
unit slot, and fix it with the two screws
removed in step 4.
●
Tightening torque guideline: 0.5 N·m or less
Note
●
When inserting the function board, be careful not
to allow it to come into contact with the edge of the
opening of the main unit slot.
The function board may be damaged.
18
English
Cover
Screw
Cautions when
moving
The display has handles for carrying. Hold them when
moving.
86-inch model
Handle
75-inch model
Note
●
Do not hold parts other than the handles.
●
The following number of people are required to carry
this unit.
:
86-inch model
4 or more
:
75-inch model
2 or more
If this is not observed, the unit may drop, resulting in
injury.
●
When carrying the unit, keep the liquid crystal panel
upright.
Carrying the unit with the surface of the liquid crystal
panel facing up or down may cause deformation of
the panel, or internal damage.
●
Do not hold the upper, lower, right and left frames or
the corners of the unit. Do not hold the front surface
of the liquid crystal panel. Also, do not hit such parts.
Doing so may damage the liquid crystal panel.
Also, the panel may crack, resulting in injury.
Handle
Advertisement
Table of Contents
