Table of Contents
Advertisement
How to reset the operation time meter
Plug in the power cord, switch on the projector and re-
set lamp time by pressing the $, % and POWER but-
tons simultaneously.
Caution:
• The lamp you have removed, do not spill liquids on
it, place it near flammable objects or where children
can touch it. Otherwise, it will cause injury or fire.
• Be sure that the projector guide is firmly inserted
between the right and left lamp guides.
Important:
• The projector will not turn on if you do not secure
the lamp lid.
• The operation time meter must be reset after the
lamp has been replaced.
• Do not reset the operation time meter unless the
lamp has been replaced.
The life of the lamp
The average life of the lamp for the projector is about
2,000 hours of consecutive use. Life span may differ
according to operating environment, and may be shorter
than 2,000 hours. Decreases in luminescence and/or
color brightness will indicate that the light source lamp
is in need of replacement. When lamp operation time
exceeds 1,500 hours, the indicator will flash alternately
between green and red (while the lamp is in operation;
when the lamp is not in operation, the indicator will
appear red only). When the lamp has been used for
about 1,900 hours, the message "LAMP!!." will appear
on the screen for one minute. When the lamp has been
used for about 2,000 hours, the projector will automati-
cally shut off for the safety of the lamp and the power
indicator light up in red. The projector cannot be used
until the lamp has been replaced, and operation timer
has been reset.
Caution:
• The light source lamp is fragile. If broken, be care-
ful not to cut yourself with glass fragments.
• The lamp life depends on the environment. For re-
placement lamps, please contact your dealer.
The projector automatically shuts off when
the lamp is used up in about 2,000 hours
and the projector will not come on until
the lamp is exchanged and operation timer
reset.
33
Advertisement
Table of Contents
