Table of Contents
Advertisement
FCC Exposure to Radio Frequency (RF) Signals
For Handset
This is a radio transmitter and receiver. It is designed and manufactured not to
exceed the emission limits for exposure to radio frequency (RF) energy set by
the Federal Communications Commission (FCC) of the U.S. Government. These
limits are part of comprehensive guidelines and establish permitted levels of
RF energy for the general population. The guidelines are based on the safety
standards previously set by both U.S. and international standards bodies.
These standards include a substantial safety margin designed to assure the
safety of all persons, regardless of age and health. This device and its antenna
must not be collocated or operating in conjunction with any other antenna
or transmitter. This product has been shown to be capable of compliance for
localized specific absorption rate (SAR) for uncontrolled environment/general
population exposure limits specified in ANSI/IEEE Std. C95.1-1992 and had
been tested in accordance with the measurement procedures specified in FCC/
OET Bulletin 65 Supplement C (2001) and IEEE 1528.
For Base
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator& your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
ISEDC Warning
This device complies with Innovation, Science, and Economic Development
Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the device.
The device is compliance with RF exposure guidelines, users can
obtain Canadian information on RF exposure and compliance.
ISEDC Specific Absorption Rate (SAR) information
For Handset
SAR tests are conducted using standard operating positions accepted by the
ISEDC with device transmitting at its highest certified power level in all tested
frequency bands, although the SAR is determined at the highest certified
power level, the actual SAR level of the device while operating can be well
below the maximum value. Before a new model device is an available for sale
to the public, it must be tested and certified to the ISEDC that it does not
exceed the exposure limit established by the ISEDC, tests for each device
are performed in positions and locations as required by the ISEDC. For body
worn operation, this model device has been tested and meets the ISEDC RF
exposure guidelines when used with an accessory designated for this product
or when used with an accessory that contains no metal.
40
General information
Advertisement
Table of Contents
