Table of Contents
Advertisement
Fault
The door cannot be opened.
The water is not draining.
Water is not flowing in. De-
tergent is not being dis-
pensed.
Cause
is activated.
The temperature is too high.
Water level is too high.
Power failure.
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
Drain pump is blocked.
is activated.
The water outlet hose is con-
nected too high.
You have not pressed Start /
Reload.
The filters in the water inflow
are blocked.
The tap is turned off.
The water inlet hose is
kinked or jammed.
Troubleshooting en
troubleshooting
Continue the programme by select-
▶
ing Spin or Drain and pressing
Start / Reload.
→ "Resuming the programme when
the programme status is Rinse
Hold", Page 36
Wait until the temperature has
▶
dropped.
→ "Cancelling the programme",
▶
Page 36
Start the Drain programme.
▶
Open the door using the emergency
▶
release.
→ "Emergency release", Page 58
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
→ "Cleaning the drain pump",
▶
Page 45
Continue the programme by select-
▶
ing Spin or Drain and pressing
Start / Reload.
→ "Resuming the programme when
the programme status is Rinse
Hold", Page 36
Install the water outlet hose at a
▶
maximum height of 1 metre.
→ "Technical specifications",
Page 62
Press Start / Reload.
▶
Clean the filters in the water inflow
▶
→ Page 48.
Turn on the tap.
▶
Ensure that the water inlet hose is
▶
not kinked or jammed.
53
Advertisement
Table of Contents
