Table of Contents
Advertisement
Deactivating Wi-Fi on the appli-
ance
Press and hold Remote Start
1.
at least three seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press Start / Reload repeatedly
3.
until the display shows OFF.
a Wi-Fi is deactivated.
Note: If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
Software update
Requirement: The display shows
UdP.
Press and hold Remote Start
1.
approx. 3 seconds.
Set the programme to position 6.
2.
a UPd appears on the display.
Press Start / Reload.
3.
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note: The software update may take
several minutes. Do not switch off the
appliance while the software update
is in progress.
Resetting the appliance network
settings
Press and hold Remote Start
1.
at least 3 seconds.
Set the programme to position 5.
2.
a The display shows rES.
Press Start / Reload.
3.
a The display shows YES .
Press Start / Reload.
4.
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
Tip: If you wish to operate your appli-
for
ance again via the Home Connect
app, you will need to reconnect it to
the Wi-Fi and to the Home Connect
app.
Remote diagnostics
Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the Home Con-
nect server and if Remote Dia-
gnostics is available in the country in
which you are using the appliance.
Tip: For further information and de-
tails about the availability of Remote
Diagnostics in your country, please
visit the service/support section of
for
your local website: www.home-con-
nect.com
Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the Home Connect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).
for
¡ Security certificate of the Wi-Fi
communication module (to ensure
a secure data connection).
¡ The current software and hardware
version of your appliance.
¡ Status of any previous reset to
factory settings.
Home Connect en
41
Advertisement
Table of Contents
