Installing The 2.5-Inch Storage Drive - Lenovo ThinkCentre M73p Hardware Maintenance Manual

5. Position the new cover presence switch so that the screw hole in the cover presence switch is aligned
with the corresponding hole in the chassis. Then install the screw to secure the cover presence
switch to the chassis.
Figure 26. Installing the new cover presence switch
6. Reconnect the cover presence switch cable to the system board. See "Parts on the system board"
on page 34.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 126.

Installing the 2.5-inch storage drive

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
This section provides instructions on how to install the 2.5-inch 2.5-inch storage drive.
To install the 2.5-inch storage drive, do the following:
104
ThinkCentre M73p Hardware Maintenance Manual