Table of Contents
Advertisement
Necessary Settings before Use
MENU
Set Lever
Be sure to confi gure the following three
settings before use.
Charging the Battery Pack
1
Set the power/mode switch to OFF.
Slide while pressing down the lock button.
Required charging / recording time
(approx.)
The values within ( ) are the times when the
LED light is on.
Battery pack Charging time
BN-VF808U
(Provided)
BN-VF815U
BN-VF823U
12
Access/Charge
Lamp
Power/Mode
Switch
MODE
ON
OFF (CHARGE)
Recording
1 hr. 15 min.
1 hr. 30 min.
(1 hr. 10 min.)
2 hr. 30 min.
2 hr. 40 min.
(2 hr. 25 min.)
3 hr. 45 min.
3 hr. 50 min.
(3 hr. 35 min.)
2
Attach the battery pack.
Slide the battery pack down until it locks in place.
Bottom of the Camera
3
Connect the AC adapter.
DC Connector
* If the provided AC adapter is AP-V14E,
connect the power cord to the AC adapter,
and plug the power cord into an AC outlet.
•
You can also connect the AC adapter using
the Everio dock connector. (
•
The access/charge lamp blinks to indicate
charging has started.
•
When the lamp goes out, charging is
fi nished. Unplug the AC adapter (or
the power cord) from the AC outlet and
disconnect the AC adapter from the camera.
8 To detach the battery pack
Slide and hold BATT. (
remove the battery pack.
8 To check the remaining battery power
See page 14.
time
NOTES
•
You can also use the camera with just the AC
adapter.
•
Please do not pull or bend the AC adapter plug
and cable. This may damage the AC adapter.
BATT.
To AC Outlet
(110V to 240V)
AC Adapter
(ex. AP-V17E)*
pg. 6)
step 2), then
Advertisement
Table of Contents
