Trouble Shooting; Led Lights; Malfunction Table; Replacing The Batteries In The Remote Control - Bosch DID106T50 Instruction Manual

Cleaning the metal mesh grease filters
Notes
Do not use any aggressive, acidic or alkaline cleaning
■
agents.
When cleaning the metal mesh grease filters, also clean the
■
holder for the metal mesh grease filters in the appliance
using a damp cloth.
The metal mesh grease filters can be cleaned in the
■
dishwasher or by hand.
By hand:
Note: You can use a special grease solvent for stubborn dirt. It
can be ordered via the Online Shop.
Soak the metal mesh grease filters in a hot soapy solution.
■
Clean the filters with a brush and then rinse them thoroughly.
■
Leave the metal mesh grease filters to drain.
■
In the dishwasher:
Note: If the metal mesh grease filters are cleaned in the
dishwasher, slight discolouration may occur. This has no effect
on the function of the metal mesh grease filters.
Do not clean heavily soiled metal mesh grease filters together
■
with utensils.
Place the metal mesh grease filters loosely in the dishwasher.
■
The metal mesh grease filters must not be wedged in.

Trouble shooting

Malfunctions often have simple explanations. Please read the
following notes before calling the after-sales service.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out and damaged power cables replaced by one of our trained
after-sales technicians. If the appliance is defective, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.

LED lights

Defective LED lights may be replaced by the manufacturer, their
after-sales service or a qualified technician (electrician) only.

Malfunction table

Problem Possible cause Solution
The appliance The plug is not
does not work plugged into the
mains
Power cut
The fuse is
faulty
The lighting The LED lights
does not work. are defective.
The button illu- The control unit
mination does is faulty.
not work.
The F indicator The grease filter
and button 1 or or the activated
the F indicator charcoal filter is
saturated.
and button 3/
G
light up.
--------
8
Connect the appliance to
the power supply
Check whether other
kitchen appliances are
working
Check in the fuse box to
make sure that the fuse for
the appliance is in working
order
Call the after-sales service.
Call the after­sales service.
Clean the filter or regener-
ate or replace the activated
charcoal filter; see the
Cleaning and maintenance
section.
Installing the metal mesh grease filter
Insert metal grease filter.
1.
Fold the metal grease filter up and click it into place.
2.
Fold the filter cover upwards.
3.
Note: Make sure that the filter cover closes properly.
Resetting the saturation displays
Once you have cleaned or replaced the relevant filters, reset
the saturation indicator to stop symbol F from flashing or
remaining lit continuously.
Make sure that the extractor hood and the lighting have been
switched off.
Press and hold the button on the extractor hood's control
#
panel until button F flashes three times.
This resets the saturation indicators.

Replacing the batteries in the remote control

Unscrew the screw.
1.
Remove the cover.
2.
Remove the battery.
3.
Insert the new battery (CR2032/3 V) correctly.
4.
Note: Dispose of flat or faulty batteries in accordance with local
regulations.
Note: Do not dispose of batteries along with general household
waste.