Table of Contents
Advertisement
Symptoms
Washing machine does
not start
Washing machine will
not spin
Door does not open
Wash cycle time delayed
Fabric softener overflow
Softeners dispensed too
early
The buttons may not
function properly.
Dry problem
Reason
Electrical power cord may not be
plugged in or connection may be
loose.
House fuse blown, circuit breaker
tripped,or a power outage has
occurred.
Water supply tap is not turned on.
Check that the door is firmly shut.
Once washing machine has
started, the door cannot be opened
for safety reasons.
If an imbalance is detected or if the
suds removing programme is on,
the wash time will increase.
Too much softener may cause an
overflow.
Too much softener may cause an
premature dispensing.
The button cannot be recognized
when the door is open.
Check water supply tap.
Solution
• Make sure plug fits tightly in
wall outlet.
• Reset circuit breaker or
replace fuse. Do not increase
fuse capacity. If problem
is a circuit overload, have
it corrected by a qualified
electrician.
• Turn on water supply tap.
• Close the door and press
the Start/Pause button. After
pressing the Start/Pause
button, it may take a few
moments before the washing
machine begins to spin. The
door must be locked before
spin can be achieved. Add 1 or
2 similar items to help balance
the load. Rearrange load to
allow proper spinning.
• Check if the 'Door Lock' icon
is illuminated. You can safely
open the door after the 'Door
Lock' icon turns off.
• This is normal. The time
remaining shown in the display
is only an estimate. Actual
time may vary.
• Follow softener guidelines to
ensure appropriate amount
is used. Do not exceed the
maximum fill line.
• Follow the guidelines provided
by the detergent manufacturer.
• Close the dispenser drawer
slowly. Do not open the drawer
during the wash cycle.
• Press again after closing the
door.
• Do not overload. Check
that the washing machine is
draining properly to extract
adequate water from the load.
Clothes load is too small to
tumble properly. Add a few
towels.
• Turn off water supply tap.
EN
41
Advertisement
Table of Contents
