Solving Projector Or Remote Control Operation Problems - Epson V11H952020 User Manual

• If you are using the USB Display function, turn on the Output audio from the projector setting in the
Epson USB Display Settings program on your computer.
• If you are using a Mac and you do not hear sound from an HDMI source, make sure your Mac
supports audio through the HDMI port. If not, you need to connect an audio cable.
• If you want to use a connected audio source when the projector is off, set the Standby Mode option to
Communication On.
• Make sure the A/V Settings options are set up correctly in the Extended menu.
• If you hear a hissing sound from your projector's speakers when projecting from a computer running
Windows 10 over a network, you may need to adjust the Windows 10 sound properties:
1. Right-click the speaker icon in the Windows taskbar and select Sounds.
2. Click the Playback tab, select the playback device, and click Properties.
3. Click the Advanced tab, set the sample rate and bit depth setting to 16 bit, 44100 Hz (CD Quality),
click Apply, and click OK.
Note: These steps may vary depending on the Windows 10 version you are using.
• If you turn the projector on immediately after turning it off, the cooling fans may run at high speed
momentarily and cause an unexpected noise. This is normal.
Parent topic:
Related references
Projector Setup Settings - Extended Menu
Projector Setup Settings - ECO Menu
Related tasks
Controlling the Volume with the Volume Buttons
Shutting Off the Picture and Sound Temporarily

Solving Projector or Remote Control Operation Problems

Check the solutions in these sections if you have problems operating the projector or remote control.
Solutions to Projector Power or Shut-Off Problems
Solutions to Remote Control Problems
Solutions to Password Problems
Solutions When a Battery Message Appears
Solving Image or Sound Problems
205