Dual Stage Shock Sensor; Auto-Start Function - Firstech CompuSTAR 2WFMR User Manual

Two-way fm remote

Table of Contents

Note: (Siren duration is 30 to 60 sec depending on the options set at the time of initial

installation.)

Dual Stage Shock Sensor

Press Buttons (I+III) for 2 seconds to activate or deactivate the dual stage

shock sensor. The dual stage shock sensor will activate 30 seconds after the

CompuStar alarm mode is armed. When the dual shock sensor is engaged,

the remote-pager security alerts will be triggered by the following:

Light impact to your vehicle will activate the first stage shock

sensor and the car siren will chirp 4 times in addition to the

parking lights flashing 4 times. The remote pager unit will beep

and the hammer icon shows up a couple times

Heavy impact to your vehicle will activate the second stage

shock sensor and the car siren will chirp for 30 to 60 seconds and

the parking lights will flash for 30 to 60 seconds. The remote-pager

will be notified audibly and a hammer icon will blink in the

CompuGLO LCD. Press Button I for a ½ second to turn off the

second stage shock sensor sirens and flashing lights.

Auto - - Start Function

Auto

Start Function

Press Button II for 2 seconds to auto-start an automatic transmission engine.

Remember that a manual key in the ignition is required to drive the car. In

addition, the anti-grind circuit (this maybe an optional feature provided by

your installer) prevents you from re-cranking the starter on a remote-started

vehicle. Press Button II for 2 seconds in order to turn off an auto-started car.

For manual transmission vehicles, please use reservation mode.

The engine will run 15 or 25 minutes (25 or 40 min for diesel) depending on

preset options at the time of installation and then shut off. If your remote-

pager has a problem starting the vehicle, CompuStar will try 2 additional

times. If the engine does not start after the third attempt, please call your

authorized CompuStar dealer.

Table of Contents