Manual Setup Using Your Browser Adding Computers to Your Network Getting to Know Your Router Front Panel Back Panel Technical Details Technical Features System Requirements Troubleshooting, Support, and Warranty Troubleshooting Technical Support Belkin International, Inc., Limited 2-Year Product Warranty Regulatory Information FCC Statement...
3) Put the CD into your computer. If the CD doesn’t open automatically, please browse to your CD drive and double- click on the Belkin Setup CD icon. [SCREENSHOT OF SETUP MENU setup menu.png] 4) Click the Setup icon on the CD menu.
This may take a few minutes to complete. Once finished, a “Success” message will appear indicating that you are connected to the Internet via your new Belkin Router. During setup you may be asked for additional information. You may need to enter a username and password provided by your ISP.
Router. Green: You are connected to your Belkin Router and it is connected to the Internet. Amber: You are connected to your Belkin Router, but it is not connected to the...
Router with a few simple steps. Using the CD 1) Put the Setup CD into your computer. If the CD doesn’t open automatically, browse to your CD drive and open the Belkin Setup CD icon. 2) Click the Setup icon on the CD menu.
23525_8820-00370_F7D1301 v1_Basic Router_0208 change 2) Select your Belkin Router from the list of available networks. You can identify your Belkin Router by locating the network name (SSID) from the card located underneath the foot of your Router. 3) Enter your network password (located on your network information card).
Page 7
23525_8820-00370_F7D1301 v1_Basic Router_0208 change [DIAGRAM front.ai] A) Router Status Light Your Router’s status is shown by the light on the front. Off: The Router is not plugged into a power source. Blinking Green: The Router is starting up. Solid Green: The Router is connected to the Internet. Blinking Amber: The Router can’t detect the modem.
NAT IP Address Sharing To save you the cost of adding IP addresses per computer in your house, your Belkin Router uses Network Address Translation (NAT) technology, allowing you to share a single IP address across your network. SPI Firewall Your Router is equipped with a firewall that will protect your network from a wide array of common attacks and viruses.
These changes can be made from any computer on your network. Belkin Router Monitor The Belkin Router Monitor application helps you to monitor your ’ Router s status and change network settings. Integrated 4-Port 10/100 Switch...
You may choose to temporarily disable this software before attempting setup. If Belkin Setup still cannot find the Router, you might choose to do a manual setup. Refer to “Manually Configuring Network Settings” in this manual for details.
Page 11
“Manually Configuring Network Settings” in this manual for an alternative setup method. Belkin Setup completed installation, but I cannot browse the Web. The light on the front of my Router is blinking amber. 1) Make sure the Router is connected to your modem with an Ethernet cable via the Router’s one WAN (modem) port.
Page 12
You may need to configure your Router to meet the specific requirements of your ISP. To search our knowledge base for ISP-specific issues, go to: http://www.belkin.com/support and type in “ISP”. 5) If you continue to have no Internet connection, refer to “Manually Configuring Network Settings” in this manual for an alternative setup method.
Page 13
23525_8820-00370_F7D1301 v1_Basic Router_0208 change Depending on local wireless traffic and Changing the wireless channel— interference, switching the wireless channel of your network can improve performance and reliability. See the section titled “Changing the Wireless Channel” for instructions on how to choose other channels.
Page 14
23525_8820-00370_F7D1301 v1_Basic Router_0208 change I am having difficulty setting up WPA security on my Router. Log in to your Router by visiting http://router/ with your web browser. Click on the “Login” button in the top right- hand corner of the screen. You will be asked to enter your password.
Router after changing any security settings. Note: Some older networking hardware supports only 64-bit WEP encryption. If your older computers cannot connect to your network, try 64-bit WEP. Technical Support http://www.belkin.com/support http://www.belkin.com/uk/support Australia http://www.belkin.com/au/support New Zealand http://www.belkin.com/au/support...
What is not covered by this warranty? All above warranties are null and void if the Belkin product is not provided to Belkin for inspection upon Belkin’s request at the sole expense of the purchaser, or if Belkin determines that the Belkin product has been improperly installed, altered in any way, or tampered with.
Page 17
23525_8820-00370_F7D1301 v1_Basic Router_0208 change Your Belkin Customer Service Representative will then instruct you on how to forward your receipt and Belkin product and how to proceed with your claim. Belkin reserves the right to review the damaged Belkin product. All costs of shipping the Belkin product to Belkin for inspection shall be borne solely by the purchaser.
ELECTROMAGNETIC COMPATIBILITY We, Belkin International, Inc., of 12045 Waterfront Drive, Los Angeles, CA 90094, declare under our sole responsibility that the device, F7D1301 v1, complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
Page 19
23525_8820-00370_F7D1301 v1_Basic Router_0208 change Caution: Exposure to Radio Frequency Radiation. The device shall be used in such a manner that the potential for human contact normal operation is minimized. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Page 20
23525_8820-00370_F7D1301 v1_Basic Router_0208 change IC Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Europe European Union Radio products with the CE or CE alert marking comply with the R&TTE Directive (1999/5/EC) issued by the Commission of the European Community.
Need help?
Do you have a question about the F7D1301 V1 and is the answer not in the manual?
Questions and answers