Maintenance And Care; Servicing Guidelines - Shindaiwa T360T Operator's Manual

Maintenance and care

Observe the following precautions when checking and maintaining your product after use:
 Turn the engine off and do not attempt to check or maintain the product until the engine has cooled.
You could burn yourself.
 Remove the spark plug cap before performing checks and maintenance.
An accident could occur if the product starts unexpectedly.
 Checking and maintenance requires specialist knowledge. If you are unable to check and maintain the product or deal with a
fault yourself, consult your dealer. Do not attempt to dismantle the product.

Servicing guidelines

Area
Air filter
Fuel filter
Spark plug
Carburettor
Cooling system
Silencer
Silencer
Angle transmission
Starter
Cut off knife
Fuel system
Screws, bolts and nuts
* Or 50 hours, whichever occurs first. ** Or 100 hours, whichever occurs first.
Area
Valve clearance
 Time intervals are maximum. Actual use and your experience will determine the frequency of required maintenance.
Maintenance and care
If you have any questions or problems, please contact your dealer.
IMPORTANT
Maintenance
Clean/Replace
Inspect/Clean/Replace
Inspect/Clean/Adjust/Replace
Adjust/Replace and adjust
Inspect/Clean
Inspect/Tighten
Clean
Grease
Inspect
Inspect/Clean
Inspect
Inspect, Tighten/Replace
Maintenance
Adjust
IMPORTANT
Maintenance and care
WARNING
Page
21
21
23
21
22
22
22
23
-
-
21
-
If pulling on the starter grip is difficult or power is low, consult
your dealer.
20
Before use
•
•
•
•
•
•
•
•
Monthly
•
•
•**
•*