Rear Surround - Panasonic SC-ALL2GN Operating Instructions Manual

Rear surround

You can add two SC-ALL2 to Panasonic SC-ALL70T (sold separately) as
rear surround speakers to enjoy 5.1 ch surround sound.
≥ Refer to the operating instructions for SC-ALL70T.
Pairing
Preparation
≥ Turn SC-ALL2 and SC-ALL70T on.
1
Start the pairing mode on SC-ALL70T.
2
Touch and hold [AUX] and [6] on each SC-ALL2 for at least
4 seconds.
≥ The network indicator goes off.
≥ [NET] starts to blink slowly.
3
Touch and hold [AUX] for at least 4 seconds.
≥ The below display is indicated.
4
Make the left and right surround speaker settings on each
SC-ALL2.
To set SC-ALL2 as left surround speaker
Touch [VOL –] to select "0-: ", and then touch [DISP] to confirm.
To set SC-ALL2 as right surround speaker
Touch [VOL +] to select ":-0", and then touch [DISP] to confirm.
When you have finished the speaker selections, SC-ALL2 will
enter pairing mode.
≥ "0000" blinks on the display.
– When pairing is successful, "good" appears on the display.
– If you try to set left and right surround speakers to the same channel on
SC-ALL2, pairing fails.
– If pairing fails, "FAIL" is displayed.
Repeat the procedure from the beginning if this occurs.
Blinking
- 36 -