Table of Contents
Advertisement
USB Charge Port
Explanation: The forecast station has an integrated USB charging port (on back) that will
charge a device when the forecast station is plugged into a power outlet.
Note: This is a power-output charging port. It does not supply power to the projection
alarm.
Connect your external device's USB charging cable (not included) to the USB charging
port.
Charging times will vary.
USB Power Output: 0.5A maximum current. Charge 0.5A devices or devices that are
self-regulating.
Note: Some USB cables are for data transfer only and cannot be used for charging. Make
sure that the USB cable you use will charge your device. Most USB cables included with
mobile devices will work for charging.
Note: Many devices may require more power to charge than provided by this forecast
station.
Projection not working
When operating on A/C power and no constant projection shows, yet it works when you
press the SNOOZE button please check:
ON/OFF: Place your hand about 2'' from the projection lens. You should see a red dot.
If not, hold and release SNOOZE/LIGHT button once to check that projection was not
accidently turned off.
A/C CORD: The projection will continuously display if the A/C cord is attached correctly
and the projection is turned on.
Check that the A/C cord attached properly. Line up the cord and push it in the
clock.
Once you are sure it is in correctly,
the A/C cord needs adjustment.
Check that the outlet or power strip has power.
Note: When you adjust the projection, you adjust the backlight at the same time.
IMPORTANT: When operating on A/C power, the backlight, projection and USB charging
port will turn off while the Projection Alarm searches for the WWVB signal, to avoid
interference. The backlight and projection will return after the 2-10 minute search (which
occurs during the late night or early morning hours). The USB charging port will then
resume working.
Projection Adjustments
When operating on A/C power the projection will display constantly unless projection is
turned off or when the clock is searching for WWVB signal.
La Crosse Technology, Ltd.
remove the batteries
www.lacrossetechnology.com/support
. If the display goes blank,
Page 11
Advertisement
Table of Contents
