Installing The Cd-R/Rw Drive; Connecting The Cables - Samsung SW-240 User Manual

Installing the CD-R/RW Drive

To install your CD-R/RW drive in the PC, proceed as follows.
1
Make sure that the PC is powered off and disconnected from any power source.
2
If necessary, attach a horizontal bracket to
both sides of the drive.
Use of the brackets depends on your computer model;
you can purchase these accessories separately from
your computer dealer.
3
Remove the cover from a free expansion slot
and install the CD-R/RW drive,
as shown in the illustration.
If you have no free expansion slot,
cover
install the drive in place of the
diskette drive.

Connecting the Cables

1
Connecting the power cable
The 4-pin power cable from the internal power unit of your computer must be
connected to the power terminal on the rear of the CD-R/RW drive.
Cut side
Note:An improperly connected power cable may cause trouble. Check the direction of
the power connector and the incline side of the CD-R/RW drive before connecting.
6
CD-R/RW
drive
Power cable
E-IDE cable
Master/slave select terminal
Audio cable
+12V DC
Ground
Ground
+5V DC
2
Connecting the E-IDE cable
Insert the IDE cable (40-pin), which is connected to the hard disk to the interface
terminal. (Place the red line of the cable close to the Pin 1.)
Pin 1
Key Slot
Red Line
When using one E-IDE cable
Connect the cable to the SL (Slave) of the Master/Slave Select Terminal at
the rear of the CD-R/RW drive.
Slave Drive (Choose the SL Jumper)
Motherboard
HDD
When using two E-IDE cable
If there is only one CD-R/RW drive, select MA (Master).
Master Drive (Choose the MA Jumper)
SEC 1
PRI1
Motherboard
HDD
If there is two CD-R/RW drive, select MA (Master) / SL (Slave).
Master Drive (Choose the MA Jumper)
Slave Drive (Choose the SL Jumper)
SEC 1
PRI1
Motherboard
HDD
(Choose the MA jumper) (Choose the SL jumper)
7