Samsung SW-216 User Manual

Cd-r/rw drive

Advertisement

CD-R/RW DRIVE
SW-216
User's Guide
FCC Compliance
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
deter-mined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Advertisement

Table of Contents
loading

Summary of Contents for Samsung SW-216

  • Page 1 CD-R/RW DRIVE SW-216 User's Guide FCC Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
  • Page 2: Table Of Contents

    Technical Specifications ........15 your dealer or local SAMSUNG representative for all repairs.
  • Page 3: Your Cd-R/Rw Drive

    Your CD-R/RW Drive Upgrading the Firmware Flash Memory The product firmware can be upgraded by downloading the updated file from the following Web site: http://www.samsungelectronics.com System Requirements Before you install the CD-R/RW drive, we strongly recommend that you check that your setup meets the system requirements listed below. Item Description Computer...
  • Page 4: Installing The Cd-R/Rw Drive

    Installing the CD-R/RW Drive To install your CD-R/RW drive in the PC, proceed as follows. Installing a jumper on the master/slave select terminal Make sure that the PC is powered off and disconnected from any power source. Install the jumper in the correct position on the terminal: MA to use the device in the master mode If necessary, attach a horizontal bracket to both sides of SL to use the device in the slave mode...
  • Page 5: Installing The Cd Record Utility

    Edit the AUTOEXEC.BAT file. Add the C:\SAMSUNG\MSCDEX /D:SSCD000 entry. The SAMSUNG device driver enables discs in the CD-R/RW drive to be read but not recorded in an MS-DOS environment; the driver is located in the D driver folder on - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - the CD record utility disc.
  • Page 6: Using The Cd-R/Rw Drive

    Using the CD-R/RW Drive To play audio or video CDs in your CD-R/RW drive, proceed as follows. Push the power button and boot the computer. Do not touch the surface of a disc; hold it by the edges. After booting the computer, open the disc compartment by pressing the Eject button.
  • Page 7: Recommended Disc Types

    Network Drive Copy the network drive contents to the hard disk and then from the hard disk Disable the PC’s screen saver. If the screen saver activates while writing data, to the CD-R/RW drive. the data tramsfer may become too slow, resulting in data writing errors. Close all application programs except writing software.
  • Page 8: Solving Technical Problems

    Solving Technical Problems Technical Specifications SAMSUNG continually strives to improve its products. Both the design specifications and these user instructions are thus subject to change without Problem Meaning / Solution notice. The CD-R/RW drive is not Check that the power, audio and IDE cables are Item detected by the computer.

Table of Contents