INSTALLATION
Installation
Installation area
!
Warning!
• Stability is important to prevent the product
from shuffling!
• Make sure that the product is not standing on
the power cord.
Before installing the machine, the area of
installation needs to -
1.Be rigid, dry and have a level surface
2.Not in direct sunlight
3.Have sufficient ventilation
4.Be have a ambient temperature above 0°C
5.Be kept far away from heat sources such as coal or gas.
Unpacking the washer dryer
!
Warning!
Packaging material (e.g. films, styrofoam) can
•
be dangerous to children.
There is a risk of suffocation! Keep all
•
packaging well away from children.
Remove the cardboard box and styrofoam packing.
1.
Lift the washer dryer out and remove the base packing. Make sure the small
2.
triangles of foam are removed with the bottom layer together in one. If not,
lay the unit down on its side and remove the small foam from the unit
bottom manually.
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the inlet hose from the drum.
Remove transport bolts
!
Warning!
• You must remove the transport bolts from the backside before using the product.
• You'll need the transport bolts again if you move the product, so make sure that you
keep them in a safe place.
Please take the following steps to remove the bolts:
1.Loosen all 4 bolts with a spanner and remove them.
2.Stop the holes with transport hole plugs.
3.Keep the transport bolts safely for future use.
9
w
w
W> 20mm