Connecting To Analog Nodes; Connecting To Nodes Or Rooms On The Internet; Communicating With Others; Disconnecting From The Node Or Room - Yaesu FTM-200DR Instruction Manual

Connecting to analog nodes

When the node to connect is an analog station, use the DTMF function on the
transceiver. For details on using the DTMF function, refer to "DTMF Operation" in the
Advance Manual.

Connecting to nodes or rooms on the Internet

1. Set the main band frequency to the local node frequency.
2. Press the [D X] key to switch to analog FM mode.
For details, refer to "Selecting the Communication Mode" in the basic operating man-
ual.
3. While pressing the microphone PTT switch, also press the DTMF ID key "#" followed
by the 5 digits of the room or node to connect.
4. Release the PTT switch on the microphone, and keep the transceiver in receiving
mode for about 10 seconds.
• Once connection is established, you will be able to hear audio.
• The connection destination screen does not appear.
DTMF codes consisting of up to 16 digits can be stored into 9 channels on the transceiver. If
you register the codes of frequently-used connection destinations in advance, you can easily
transmit the code by selecting it on the function menu screen and pressing PTT. For details,
refer to "DTMF Operation" in the Advance Manual.

Communicating with others

1. Press the PTT switch, and speak into MIC.
2. Release the PTT switch.
The transceiver switches to receive mode.

Disconnecting from the node or room

1. While pressing the PTT switch on the microphone, also press "#" followed by "99999"
(DTMF disconnect command).
2. Disconnects the node or room.
17