Asko DWCBI241.S.AU Operating Instructions Manual page 18

Problem
Water remains in the dishwasher.
Bad odour in dishwasher.
The dishes are not dry enough.
18
Possible causes
The filters are blocked.
The filters are not fitted correctly.
Debris in the drainage pump.
Drainage pump stop missing.
Kink in drainage hose.
Blocked drainage hose.
Dirt around the seals and in corners.
Low temperature programs have been selected
for a prolonged period.
The dishwasher is not fully loaded.
Rinse aid needs topping up or dosage is set too
low.
The setting TAB is activated and all-in-one
detergent with insufficient drying effect is being
used.
Action
Clean the coarse and fine filters.
Check that the filter handle is locked in the stop
position. The handle should point towards the
back of the dishwasher.
Clean the drainage pump. See the chapter Care
and cleaning.
Check that the coloured stop on the right in the
bottom drain is in place. See the chapter Care
and cleaning.
Check that the hose is free from kinks and sharp
bends.
Disconnect the drainage hose where it connects
to the sink unit's water trap. Check that no debris
has fastened and that the connection has an
inner diameter of at least 14 mm.
Clean with washing-up brush and low foaming
cleaner.
Run a program with a higher temperature once
or twice a month. Or run a self-cleaning
program. See Self-cleaning in Chapter Using
the dishwasher.
Fully load the dishwasher.
Top up with rinse aid or increase the rinse aid
dosage level. See the chapter Settings.
Change your all-in-one detergent or deactivate
the setting TAB and top up with salt and
separate rinse aid. See Rinse aid in the chapter
Settings.
Open the door a little once the program has
finished.