Opengear IM4216-34 Quick Start Manual page 2

Note: The computer must have an IP address in the same network range
(192.168.0.xxx) as the console server. Alternately, you can use the
to set the IP address (refer
also DHCP client enabled by default. It will automatically accept any network IP address
assigned by any DHCP server on your network – and will then respond at both
192.168.0.1 and its DHCP address.
Select System: IP then Network Interface and check DHCP or Static for

Configuration Method
The second Ethernet network port (
for failover/OoB access (refer User Manual).
The console server's firewall determines which protocols/ services can be
Note:
used to access which ports/ devices. Please refer to the User Manual and FAQs before
changing any of the default services or access settings.
IM4216-34 Quick Start (520038-Rev 1.0)
User Manual
or online FAQ for details). The console server
NETWORK2
) is inactive by default. It can be set up
The integrated Ethernet switch provides a 32 port
management LAN with firewall/router isolation and
DHCP server. By default these ports are inactive.
To activate:
Select System: IP then Management LAN

Interface and uncheck Disable

Enter the IP Address and Subnet Mask for
the Management LAN network segment,
leaving Gateway and DNS fields blank)

If you wish to use the DHCP server, refer to
the User Manual
ARP Ping
command
Page 2