Panasonic LUMIX DMC-G85 Operating Instructions For Advanced Features page 301

11. Connecting to other equipment
•
Disconnect the USB connection cable after printing.
•
Use a battery with sufficient battery power or the AC adaptor (optional). If the remaining battery
power becomes low while the camera and the printer are connected, the status indicator blinks
and the alarm beeps. If this happens during printing, stop printing at once. If not printing,
disconnect the USB connection cable.
•
Do not disconnect the USB connection cable while [å] (Cable disconnect prohibit icon) is
displayed.
(May not be displayed depending on the type of printer used.)
•
Before inserting or removing a card, turn the camera off, and disconnect the USB connection
cable.
Not available in these cases:
•
Motion pictures, 4K burst files, and images recorded with the Post Focus function cannot be
printed.
Selecting a single picture and printing it
1
Press 2/1 to select the picture and then press
[MENU/SET].
2
Press 3 to select [Print start] and then press [MENU/
SET].
Selecting multiple pictures and printing them
1
Press 3.
2
Press 3/4 to select an item and then press [MENU/SET].
[Multi Select]
[Select All]
[Print Set (DPOF)] Prints the pictures set in [Print Set] only.
[Favorite]
3
Press 3 to select [Print start] and then press [MENU/SET].
Multiple pictures are printed at one time.
•
Press 3/4/2/1 to select the pictures and then press [MENU/
SET].
(When [MENU/SET] is pressed again, the setting is cancelled.)
•
After the pictures have been selected, press 2 to select [OK], and
then press [MENU/SET].
Prints all the stored pictures.
Prints the pictures set as favourites only.
301
PictBridge PictBridge
(P246)
(P245)