Table of Contents
Advertisement
Command Control Settings
Press the ENTER button to enter the Command Control Settings sub menu.
I
TEM
Control By
Network State
Projector ID
Network State
I
TEM
Network State
DHCP
Projector IP Address
Subnet Mask
Default Gateway
DNS
Apply
Press the ◄► buttons to select projector remote command control. (Range: RS232/ RJ45)
Press the ENTER button to enter the Network State sub menu.
See Network State on page 23.
Press the cursor ◄► button to set Projector ID number for projector control by RS232 com-
mand.
Displays the network connection status.
Press ◄► to turn DHCP On or Off.
Note: If you select DHCP Off, complete the IP Address, Subnet Mask, Gateway, and DNS
fields.
Enter a valid IP address if DHCP is turned off.
Enter a valid Subnet Mask if DHCP is turned off.
Displays the default Gateway address on the network.
Enter a valid DNS name if DHCP is turned off.
Press
(Enter) / ► to confirm settings.
DLP Projector – User's Manual
D
ESCRIPTION
D
ESCRIPTION
– 23 –
Advertisement
Table of Contents
